Aaron: 847 AWHP.
Posted: Sun Sep 22, 2013 8:53 pm
so, i decided to dyno without tuning just to see where we left this season, for power. and it did pretty good i must say.
847 AWHP. 611 WTQ. and lots of tire slip on the rollers. 46+ psi, still with a small port head too
and i have pulled the plug on this season. work and weather are getting non-compliant, we only have a couple weeks left anyhow, and i figure why not. i wanted to hit it ONE MORE TIME with the sequential shifter now being back, but alas i just decided to skip it. i could quite possibly have gotten it down some more, but leaving off with 167 mph trap speed and still 9.41 is good enough.
one of the bigger changes i plan to do is an 8.8" live axle rear end and a 4-link setup. still Quattro (for now) and the ability to switch to RWD only is much easier at that point
[youtube]http://www.youtube.com/watch?v=uNnvNCG-428[/youtube]
847 AWHP. 611 WTQ. and lots of tire slip on the rollers. 46+ psi, still with a small port head too
and i have pulled the plug on this season. work and weather are getting non-compliant, we only have a couple weeks left anyhow, and i figure why not. i wanted to hit it ONE MORE TIME with the sequential shifter now being back, but alas i just decided to skip it. i could quite possibly have gotten it down some more, but leaving off with 167 mph trap speed and still 9.41 is good enough.
one of the bigger changes i plan to do is an 8.8" live axle rear end and a 4-link setup. still Quattro (for now) and the ability to switch to RWD only is much easier at that point
[youtube]http://www.youtube.com/watch?v=uNnvNCG-428[/youtube]
