Page 1 of 1
WTB: URS6/200/V8 parts
Posted: Wed Dec 07, 2016 5:10 pm
by nuugen
Hello, I need to buy the following parts if anyone has them. I am located in Northeast Ohio and you can text me at 440-452-8539..
---Cary
1. URS6 /V8q/200 20vFuel tank, non-rusty please
2. RS2-equipped 3B ecu
3. 91 V8q ac compressor
4. URS6 front bumper in good shape..
Thanks for any and all help..
Re: WTB: URS6/200/V8 parts
Posted: Wed Dec 07, 2016 6:48 pm
by varia
got a gas tank from a 94 s4, California, no rust.
im not about the shipping/cost
Re: WTB: URS6/200/V8 parts
Posted: Wed Dec 07, 2016 6:51 pm
by alxdgr8
I might have the AC compressor...I think it's the one I tried to get working on my AEB B4 swap but ended up using a UrS one. I'll double check the part numbers.
Re: WTB: URS6/200/V8 parts
Posted: Wed Dec 07, 2016 8:57 pm
by nuugen
ok, btw there are a couple different units out there, mine has the lines coming out of the left (drivers) side of the compressor
Re: WTB: URS6/200/V8 parts
Posted: Wed Dec 07, 2016 8:57 pm
by pilihp2
Would a compressor from a 4.2 ABH work?
Re: WTB: URS6/200/V8 parts
Posted: Thu Dec 08, 2016 10:40 am
by 32vquattro
pilihp2 wrote:Would a compressor from a 4.2 ABH work?
No, thats a Zexel unit. He needs a Denso compressor. The compressor is easy to find new. The clutch is the hard part.
Re: WTB: URS6/200/V8 parts
Posted: Fri Dec 09, 2016 6:48 pm
by nuugen
Yes I am looking to just get a used one. I don't care if it is any good as long as the pulley and clutch don't make noise. Theoretically I could pull the clutch and pulley from the Zexel unit and swap it onto mine