The Project Pad

Soooooo......

If I decide to offer CA bushings, I will basically offer every bushing available for the urQ/4kq/80/90 etc.

I really like the powerflex ones but just gauging interest to see if I should invest into these.

I would imagine I will come in a little less than the powerflex ones on price.

They will be 95a for those interested.

Take 034 bushings as an equal value trade?

PRY4SNO wrote:Take 034 bushings as an equal value trade?

Any you know I'm interested. Might as well complete my set. I would need them for both stamped and forged.

PRY4SNO wrote:Take 034 bushings as an equal value trade?

Only if you send 20 6-packs of irish death

I inspired this offering!

AngryTaco wrote:Soooooo......

If I decide to offer CA bushings, I will basically offer every bushing available for the urQ/4kq/80/90 etc.

I really like the powerflex ones but just gauging interest to see if I should invest into these.

I would imagine I will come in a little less than the powerflex ones on price.

They will be 95a for those interested.

Fvck yes!!!

I would want a full set of bushings for my B4 stamped control arms front and AND rear. Probably sway bar bushings too.
My rear subframe is from a B5, but that should not matter. I am looking upgrade my handling now.

What kind of ballpark figure are we talking about for this?

If you could make some good strut mounts for the B3/B4 like the Mance, that would be killer.

I'd be interested in some rear B4 bushings. Already got a set of Mance Acetron front bushings.

Would be interest in a set for my CGT.
Looking forward to tranny mounts for the C4 too.